Each M.Sc. student required to complete a minimum of 24 units of courses, including 3 units of required courses^#. Subject to the approval of the Programme Directors concerned, students can take at most two courses from other M.Sc. Programmes within the Faculty of Engineering. Full-time mode students are allowed to take other day time postgraduate courses offered by the Department of Electronic Engineering. Students may apply for course and unit exemption for a maximum of 2 courses (6 units) subject to the approval of the Programme Director and the Dean of the Graduate School on a case-by-case basis, taking into account individual circumstances. In any case, at least 6 courses (18 units) must be from ELEG5xxx courses.

The following table lists the M.Sc. courses in Electronic Engineering. About eight of them are offered each year. The latest teaching time table can be found in the Graduate School web page. (http://www.gs.cuhk.edu.hk/page/TeachingTimetable)

^#Required course (applicable to students admitted in 2024-25 and thereafter)

Students, subject to approval, can also elect the following graduate-level lecture courses primarily for research students:

For more graduate courses, please refer here

or courses from other M.Sc. Programmes within the Faculty of Engineering:

• A student must take and pass 8 courses including a required course^# in this programme with a GPA of 2.0 or above to graduate.
• A student will be discontinued from study if the student has a GPA below 1.0 or fails to have probation lifted after being put on academic probation for two consecutive terms of attendance (probation threshold . below 2.0).
• The length of study is usually 1 academic year in full-time mode and 2 academic years in part-time mode. Each year has 2 terms.
• Each course usually consists of 36 lecture hours and 6 hours of tutorials/hand-on training over a period of 14 weeks.
• Subject to the approval of the Programme Directors concerned, students can take at most two courses from other M.Sc. Programmes within the Faculty of Engineering.
• Full-time mode students are allowed to take other day time postgraduate courses offered by the Department of Electronic Engineering.
• Students may apply for course and unit exemption for a maximum of 2 courses (6 units) subject to the approval of the Programme Director and the Dean of the Graduate School on a case-by-case basis, taking into account individual circumstances.

Award of Degree

Graduates will receive a Master of Science Degree in Electronic Engineering from The Chinese University of Hong Kong if satisfy the credit unit and GPA requirement.

^#Applicable to students admitted in 2024-25 and thereafter

每位攻讀碩士學位的學生必須修讀並通過課程的8門科目（24學分），包括一門必修的畢業論文^#。在課程主任的批准下，學生最多可以從工程學院其他碩士學位課程中選擇兩門科目。全日制學生可以參加電子工程學系提供的其他研究生課程。特殊情況下，經過課程主任和研究院院長批准，學生最多可以申請免除2門科目（6學分）。但無論如何，至少有6門科目（18學分）必須來自ELEG5xxx的科目。

下表列出了電子工程學理學碩士的課程。每年大約提供8個科目，最新的教學時間表可以在研究院網頁上找到。((http://www.gs.cuhk.edu.hk/page/TeachingTimetable)

^＃必修科目（適用於2024-25及以後入學的學生）

Students, subject to approval, can also elect the following graduate-level lecture courses primarily for research students:

For more graduate courses, please refer here

or courses from other M.Sc. Programmes within the Faculty of Engineering:

• 學生必須修滿8門科目包括一門畢業課程^#，並且GPA大於或等於2.0才能畢業。
• 學生GPA低於1.0或者連續兩學期在試讀學期中GPA低於 2.0將被要求退學。
• 全日制課程為期1年，兼讀制課程為期2年。每年有2個學期。
• 每門科目時長通常為14個星期，一共由36個課時和6小時的輔導/實踐培訓組成。
• 如果得到有關課程主任的批准，學生最多可以從工程學院其他研究生課程中選擇兩門科目修讀。
• 全日制學生可以修讀電子工程學系提供的其他日間研究生科目。
• 特殊情況下，經過課程主任和研究院院長批准，學生最多可以申請轄免修讀2門科目（6學分）。

獲得學位

如果修滿學分並且達到GPA要求，畢業生將獲得香港中文大學電子工程學理學碩士學位。

^#適用於2024-25及以後入學的學生